Step 1. Clean dent surface.

Step 2. Put the glue sticks to gun and heat, connect the power source and preheat for 5-10 minutes. （This dent repair kit is come with glue gun and glue tabs, There is a switch on the handle of the glue gun, which needs to be turned on and preheated for 5-8 minutes before the glue flowing out can be used.）

Step 3. According to the dent size to choose the Glue Puller Tab, then put the heated glue on puller tab, immediately place puller tab in the center of the dent and hold on until it sticks.

Step 4. Let the glue cool for about 5-8 minutes. The cooling time should be less than 10 minutes and should be shorter slightly in winter. (The applicable temperature for glue sticks ranges from 0 to 40degrees. If the temperature dropped below 0 degree, the hot melt glue mayquickly curdle and cannot be sticked. For this case, just heat the joint with a hairdryer before use this product.)

Step 5. After the glue cooling,use a golden dent lifter or bridge puller to align and press the puller to pull up the dent. Repeat the above steps until the dent disappear.

Step 6. After finishing the dent,use the alcohol to clean the glue which on the car and the puller tabs.

Note: For detailed operation and more tools, please refer to the instruction manual. (Tips: This dent repair tool kit can effectively repair 90% of the repair effect, but not repair 100% of the perfect effect. Please read the instructions carefully before buying.)

Packing Listing

1 x T-bar Dent Puller

2 x Red Pro Dent Glue Tabs

16 x Black Pro Dent Glue Tabs

The dent puller kit is suitable for most large dents. The effective effect on the dents of automobiles and other metal surfaces can be widely used on the dents of multiple products.